Change OSPF route types from E2 to Internal

Unanswered Question
Jun 2nd, 2009

Greetings all,

I need to change OSPF E2 routes to internal. I have tried to weight E2 to be preferred, but no luck. Is there a basic way to remark the routes?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
slmansfield Wed, 06/03/2009 - 06:12

"distance OSPF" will allow you to adjust administrative distance based on route type.

The IP "distance" command will provide greater granularity to select specific routes.


This Discussion