I noticed the recent post concerning the upcoming firmware for the WAP4400N, and so I'd like to ask the same question for the WAP4410N. It seems that firmware 1.0.12 has been around a long time, and has some distinct issues. May I ask the current timeline, the expected firmware version number, and a synopsis of bugfixes and/or new features?
In addition, if anyone has any experiences they'd like to share about these 4410s, I'd like to hear it. I have seen just a few too many forum entries about basic stability of these units, but I do need the features that the 4410 has. I am about to deploy 7 of these in a campus config, with dual SSIDs on dual VLANs, one encrypted and non-broadcasting for secure staff access, one open and broadcast for guest access, then controlled by an external hotspot controller. We go live in one week, and while I doubt my job depends on the performance of this network, my mojo certainly does.
-Bug: If I configure logging and automatic email, save it, reboot the AP, all settings are disabled.
-Bug: If I clone using the export file, I get inconsistant results. I eventually factory reset all and built by hand, one by one. Also if you read the config file, there are at least two bad misspellings, such as HTTP_Rediret=0 and IPv4_Pirmary_DNS. Just a bit disconcerting.
-Feature requests: It would be nice to have some of the basics like associated clients w/MAC addresses, xmit power control, site survey, etc. The feature set is lighter than some consumer grade APs.
Thanks in advance for any info.