06-03-2009 06:55 AM - last edited on 03-25-2019 07:51 PM by ciscomoderator
I noticed that Inline Power isn't supported for this type of model and I was wondering if a CAT 3550 was able to provide enough power to make it work.
This is what I basically did for the config part on the switch.
Switch(config-if)#power inline auto
The Phone stays on a reset loop all the time.
Any ideas?
06-03-2009 10:01 AM
Try "power inline delay shutdown 20 initial 300" port command.
HTH,
Chris
06-03-2009 10:08 AM
That works thanks...what exactly is going on during the delay?
06-03-2009 10:47 AM
Not sure exactly how it operates differently for these phones and why it's needed, but it works :-)
HTH, please rate all uselful posts!
Chris
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: