06-03-2009 06:55 AM - last edited on 03-25-2019 07:51 PM by ciscomoderator
I noticed that Inline Power isn't supported for this type of model and I was wondering if a CAT 3550 was able to provide enough power to make it work.
This is what I basically did for the config part on the switch.
Switch(config-if)#power inline auto
The Phone stays on a reset loop all the time.
Any ideas?
06-03-2009 10:01 AM
Try "power inline delay shutdown 20 initial 300" port command.
HTH,
Chris
06-03-2009 10:08 AM
That works thanks...what exactly is going on during the delay?
06-03-2009 10:47 AM
Not sure exactly how it operates differently for these phones and why it's needed, but it works :-)
HTH, please rate all uselful posts!
Chris
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide