Outside Interface

Answered Question
Jun 3rd, 2009

what are the commands to configure an interface as the outside interface on a router and leave all others as inside

I have this problem too.
0 votes
Correct Answer by srue about 7 years 7 months ago

ip inspect INSPECTNAME in

the easiest way to use that command is to set up your inspection rules and then apply that command on the inside interface.

http://www.cisco.com/en/US/docs/ios/sec_data_plane/configuration/guide/sec_cfg_content_ac_ps6350_TSD_Products_Configuration_Guide_Chapter.html

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
srue Wed, 06/03/2009 - 08:52

can you be more specific? NAT? IOS Firewall? etc?

Or do you mean in general?

Actions

This Discussion