×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

Unable to reset AP1242 to default

Unanswered Question
Jun 3rd, 2009
User Badges:

I have replaced removed some of AP1242 from one location (these APs had previously had joined the controller) NOw I'm trying to reset them to factory default so that I can send them to a different location and I'm having hard time to rese them, from the command line it say "command is locked" . When I press the mode button and reboot it only clears the ip add and mask but i can still see the gateway and the host name information. Can someone help me how to reset AP1242 to factory default without connecting to the controller.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Leo Laohoo Wed, 06/03/2009 - 14:44
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 LAN, Wireless

When you console into the LAP, you flash should contain TWO (2) IOS, namely: The Recovery IOS (RCV) and the LAP IOS. Delete the LAP IOS using the command delete /f /r flash: .


Once the LAP IOS has been deleted and boot into the RCV image, you can run the CLI clear lwap private.


Does this help?

Actions

This Discussion