IP Phone Statistics

Unanswered Question
Jun 3rd, 2009
User Badges:


For the phone statistics displayed by double clicking ??, what is the measurement unit for MaxJtr? Is it in milliseconds? What about the same MaxJtr in IP Communicator? I have both calling an IVR and the Jitter displayed on the 7940G is most of the time 10 times more than that displayed on the softphone. Any ideas?

Thanks in advance.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Chris Deren Wed, 06/03/2009 - 17:42
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,
  • Cisco Designated VIP,

    2017 IP Telephony, Contact Center, Unified Communications

Yes it is in milliseconds. The recommended jitter is below 30 ms.



Chuan Liu Wed, 06/03/2009 - 17:59
User Badges:

Thanks Chris,

Why does the softphone always have much smaller value? I have tested tens of times and seen no exceptions.




This Discussion