06-04-2009 04:56 AM - edited 03-06-2019 06:06 AM
Hi,
I got this message after i reload it "!!! WARNING: The switch is not usable !!!", i made a IOS UPDATE before the "reload", when i tried to roll back the IOS the switch doesn't works, the same message was displayed.
See attached the Switch initialization.
06-04-2009 07:26 AM
This tells me you might have a H/W problem.
POST: PortASIC CAM Subsystem Tests : Begin
HTD POST: Basic Test Failed
POST: POST Failed
POST: PortASIC CAM Subsystem Tests : End, Status Failed
you could format flash and upload old IOS via console and see if it works. a faster way to find out would be to replace existing flash with one that has your old IOS if at all possible.
HTH
Sam
HTH
Sam
06-04-2009 03:17 PM
The ASIC has failed during POST. I recommend you contact Cisco to get the product RMA-ed.
If you are lucky, sometimes you can get a 10 Business Day lifetime warranty on the appliance.
Hope this helps.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: