NAM module booting from maintenance image

Answered Question
Jun 4th, 2009
User Badges:

Hi everybody,


I have a NAM in a 6509-E chassis with sup720, and every time I reset this module it boots with its maintenance image instead of with its application image. The only way I have meneged to boot the NAM with application image is with the command "hw-module module <slot> reset hdd:1". But, if I reset it without "hdd:1" argument (by default) or I reload it, the NAM boots again with maintnance image.

What can I do to set application image as the default image?


Thanks in advanced and best regards,


Luis

Correct Answer by Joe Clarke about 7 years 11 months ago

Try hardcoding the hdd:1 into the config of the 6500:


boot device module hdd:1


Then see if the default reset command works.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Joe Clarke Thu, 06/04/2009 - 09:10
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    Founding Member

Try hardcoding the hdd:1 into the config of the 6500:


boot device module hdd:1


Then see if the default reset command works.

Actions

This Discussion