Configure SIP with CLI

Unanswered Question
Jun 5th, 2009
User Badges:

Hi!


I'm trying to get the UC500 to work with our SIP providers. Since I'm in Sweden I can't use the fancy preconfigured SIP providers.

I can't get it to work when doing it in the CCA 2.0. I wan't to se exactly how it's setup and if it registers with the provider.


How do I set up a SIP trunk from the CLI?

How to monitor the registration?


In CCA 2.0 you get the option to authenticate on user level instead of digest authentication. Does this mean that I can use a provider that issues usernames and password for each telephonenumber? The provider in this case is Telia.


Thanks!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Maulik Shah Fri, 06/05/2009 - 17:35
User Badges:
  • Silver, 250 points or more

A CLI guide is here:

http://www.cisco.com/en/US/products/sw/voicesw/ps4625/products_configuration_example09186a00808f9666.shtml


Also, you can read section 4.4 at

https://www.myciscocommunity.com/servlet/JiveServlet/previewBody/1560-102-1-1933/UC500-SIPTrunking-Wiki-062008.pdf


Yes you can have a username / password pair per phone number for Registration purposes, support for extending this to INVITEs is on our roadmap.

Actions

This Discussion

Related Content