Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
3954
Views
0
Helpful
1
Replies

Configure SIP with CLI

m.junghage
Level 1
Level 1

‎06-05-2009 01:39 AM - last edited on ‎03-25-2019 10:37 PM by Community Manager

Hi!

I'm trying to get the UC500 to work with our SIP providers. Since I'm in Sweden I can't use the fancy preconfigured SIP providers.

I can't get it to work when doing it in the CCA 2.0. I wan't to se exactly how it's setup and if it registers with the provider.

How do I set up a SIP trunk from the CLI?

How to monitor the registration?


In CCA 2.0 you get the option to authenticate on user level instead of digest authentication. Does this mean that I can use a provider that issues usernames and password for each telephonenumber? The provider in this case is Telia.

Thanks!

Labels:
0 Helpful
1 Reply 1

Maulik Shah
Level 5
Level 5

‎06-05-2009 05:35 PM

A CLI guide is here:

http://www.cisco.com/en/US/products/sw/voicesw/ps4625/products_configuration_example09186a00808f9666.shtml

Also, you can read section 4.4 at

https://www.myciscocommunity.com/servlet/JiveServlet/previewBody/1560-102-1-1933/UC500-SIPTrunking-Wiki-062008.pdf

Yes you can have a username / password pair per phone number for Registration purposes, support for extending this to INVITEs is on our roadmap.

0 Helpful
Customers Also Viewed These Support Documents