Problem with Client Disconnect

Unanswered Question
Jun 5th, 2009
User Badges:

I Have problem with Client Disconnect, we use WLC 4400 and LAP 1250 configured with HREP mode. Some clients are disconnect, how can I do Trobleshooting about that ?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Vinay Saini Sat, 06/06/2009 - 23:51
User Badges:
  • Cisco Employee,


when you are facing this issue is ur HREAP AP is connected mode ?

What are the authentication type used for the client ?

1. Issue the command "debug client " on the controller to further debug

2.Sniff the air with the client MAC address on the channel where client is connected using omnipeek.



George Stefanick Sun, 06/07/2009 - 05:32
User Badges:
  • Purple, 4500 points or more
  • Community Spotlight Award,

    Best Publication, October 2015

The client debug is a good place to start and here is a document explaining that process.

You many want to do dot11 debugs as well. But sniff the air first and see what activity you see... Also check your clients for a possible misconfig.


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode