Access Point issues

Unanswered Question
Jun 5th, 2009

I have six AIR-LAP1252AG-E-K9 access points. Users have complained about connection issues. I have noticed in the last three days that certain access points stop working. They just don't allow clients to associate until they are rebooted. Then they work fine. I have resetall of them at least once, but two of them just stop functioning properly. Can anyone tell me why this is? It is not efficient to keep rebooting them.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
ehlers.kevin Fri, 06/05/2009 - 07:22

You could be running into this nasty bug CSCsz05479. It affects both 1250s and 1140s.

"Symptom: An AP1252 may be seen to stop emitting frames, i.e. stop forwarding data from the LAN to the wireless channel."


Vinay Saini Sat, 06/06/2009 - 23:46

Hii ,

Please login to AP and issue the command "show controller d1" and check the state of Beacons and Probes . If both are enabled and you can see any beacons or frames on air , you might be hitting some bug.

Which code you are using ?

RVirdi Fri, 07/17/2009 - 00:05

I apologise only replying to one of the messages.

The APs are running:


Software Version

Boot Version

IOS Version 12.4(13d)JA

Mini IOS Version


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode