RME - Software Mgmt X SNMP RW

Answered Question
Jun 5th, 2009

Hi,

I was trying to add an Cisco Software Image to CWLMS (RME) software repository (on Device Center > Management Tasks > Add Images to Software Repository). Then I got the error showed on attached image. I don't have SNMP RW community configured on CWLMS for this device because it is not allowed to enable on customer network.

So, my question is: is it necessary to configure SNMP RW community to take devices' software image to RME software repository?

Thank you.

Best Regards.

Flaviano.

I have this problem too.
0 votes
Correct Answer by Joe Clarke about 7 years 6 months ago

Yes, it is necessary. The sync will be done using an SNMP-triggered operation on the CISCO-FLASH-MIB.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Joe Clarke Fri, 06/05/2009 - 11:33

Yes, it is necessary. The sync will be done using an SNMP-triggered operation on the CISCO-FLASH-MIB.

Actions

This Discussion