How to set speed and duplex for APs

Unanswered Question
Jun 8th, 2009

Hi,

I'm using two 4402 running the following versions:

(Cisco Controller) >show sysinfo

Manufacturer's Name.............................. Cisco Systems Inc.

Product Name..................................... Cisco Controller

Product Version.................................. 5.2.157.0

RTOS Version..................................... 5.2.157.0

Bootloader Version............................... 4.2.112.0

Emergency Image Version.......................... 5.2.157.0

Build Type....................................... DATA + WPS

Where can I set the speed/duplex mode for the APs?

In earlier versiones there was a "config ap ethernet"-command.

Any ideas?

Regards Dirk

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
tsennett Mon, 06/08/2009 - 12:03

This works in 5.0.148.2

config AP ethernet duplex (x) speed (x) (AP NAME)

Dirk Woellhaf Mon, 06/08/2009 - 23:58

Thanks for the reply,

but I don't want to downgrade.

Does anyone know if thess commands are back in the upcoming versions?

regards

Vinay Saini Tue, 06/09/2009 - 03:10

Yes ,

These commands are there new versions.

Haven't checked in the version you mentioned,But should not have got removed.

Thanks

Vinay

Dirk Woellhaf Tue, 06/09/2009 - 03:30

Good to know.

Any suggestion when Version 6.x will be available for 440x series?

Regards Dirk

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode