06-08-2009 06:40 AM - edited 07-03-2021 05:41 PM
Hi,
I'm using two 4402 running the following versions:
(Cisco Controller) >show sysinfo
Manufacturer's Name.............................. Cisco Systems Inc.
Product Name..................................... Cisco Controller
Product Version.................................. 5.2.157.0
RTOS Version..................................... 5.2.157.0
Bootloader Version............................... 4.2.112.0
Emergency Image Version.......................... 5.2.157.0
Build Type....................................... DATA + WPS
Where can I set the speed/duplex mode for the APs?
In earlier versiones there was a "config ap ethernet"-command.
Any ideas?
Regards Dirk
06-08-2009 12:03 PM
This works in 5.0.148.2
config AP ethernet duplex (x) speed (x) (AP NAME)
06-08-2009 11:58 PM
Thanks for the reply,
but I don't want to downgrade.
Does anyone know if thess commands are back in the upcoming versions?
regards
06-09-2009 03:10 AM
Yes ,
These commands are there new versions.
Haven't checked in the version you mentioned,But should not have got removed.
Thanks
Vinay
06-09-2009 03:30 AM
Good to know.
Any suggestion when Version 6.x will be available for 440x series?
Regards Dirk
07-01-2009 12:48 PM
Just to let you all know,
Issue is fixed in version 6.0
regards
07-01-2009 12:48 PM
Just to let you all know,
Issue is fixed in version 6.0
regards
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: