cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
685
Views
0
Helpful
6
Replies

How to set speed and duplex for APs

Dirk Woellhaf
Level 1
Level 1

Hi,

I'm using two 4402 running the following versions:

(Cisco Controller) >show sysinfo

Manufacturer's Name.............................. Cisco Systems Inc.

Product Name..................................... Cisco Controller

Product Version.................................. 5.2.157.0

RTOS Version..................................... 5.2.157.0

Bootloader Version............................... 4.2.112.0

Emergency Image Version.......................... 5.2.157.0

Build Type....................................... DATA + WPS

Where can I set the speed/duplex mode for the APs?

In earlier versiones there was a "config ap ethernet"-command.

Any ideas?

Regards Dirk

regards, Dirk (Please rate if helpful)
6 Replies 6

tsennett
Level 1
Level 1

This works in 5.0.148.2

config AP ethernet duplex (x) speed (x) (AP NAME)

Thanks for the reply,

but I don't want to downgrade.

Does anyone know if thess commands are back in the upcoming versions?

regards

regards, Dirk (Please rate if helpful)

Yes ,

These commands are there new versions.

Haven't checked in the version you mentioned,But should not have got removed.

Thanks

Vinay

Good to know.

Any suggestion when Version 6.x will be available for 440x series?

Regards Dirk

regards, Dirk (Please rate if helpful)

Just to let you all know,

Issue is fixed in version 6.0

regards

regards, Dirk (Please rate if helpful)

Just to let you all know,

Issue is fixed in version 6.0

regards

regards, Dirk (Please rate if helpful)
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: