cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
308
Views
0
Helpful
3
Replies

Caller-id enable issue in 124-24T

blevins-m
Level 1
Level 1

We have loaded IOS 124-24T on a 2800 series router. We were getting a buzzing noise on inbound calls to our FXS lines. Removing the caller-id enable command from the voice-ports resolved the issue.

Problem we are having is that once the router is reloaded the caller-id enable command comes back as well as the issue.

The startup config will show correctly without the caller-id enable command, but the running config will have it.

Has anyone had this issue? Is there a walk around?

This problem does not happen in 124-20T3, but it does happen with 124-22T through 124-24T. And we have to at least be at 124-22T for Call Mgr v7 which we are upgrading to soon.

Thanks,

Mark

3 Replies 3

Hi Mark,

Can you send 'show run' 'show version'?

-nick

Hi Nick,

Show start, Show run, and Show ver output attached.

Thanks,

Mark

I don't see anything in here that would cause that.

Only suspicion is SNMP, but that looks pretty harmless.

I'll poke around a bit, but I can't explain this yet.

-nick

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: