06-10-2009 05:46 AM - edited 03-10-2019 04:39 AM
I am getting the following on the IPS auto-update
Auto Update Statistics
lastDirectoryReadAttempt = 02:30:00 Eastern Tue Jun 09 2009
= Read directory: http://198.133.219.25/pcgi-bin/tablebuild.pl/ips6-sigup
= Error: http error response: 400
lastDownloadAttempt = N/A
lastInstallAttempt = N/A
nextAttempt = 02:30:00 Eastern Wed Jun 10 2009
Auto Update Statistics
lastDirectoryReadAttempt = 02:13:00 Eastern Wed Jun 10 2009
= Read directory: http://198.133.219.25/pcgi-bin/tablebuild.pl/ips6-sigup
= Error: http error response: 400
lastDownloadAttempt = N/A
lastInstallAttempt = N/A
nextAttempt = 02:13:00 Eastern Thu Jun 11 2009
Can you tell me what I am doing wrong.
06-10-2009 11:32 PM
Ensure your SSM can connect to internet, try by pinging from SSM to 4.2.2.2
Also correct the URL..
https://198.133.219.25//cgi-bin/front.x/ida/locator/locator.pl
06-11-2009 04:02 AM
Thanks for the response. I change the URL and it did not make any difference. I am able to ping 4.2.2.2
I still getting the 400 error. Anything else I need to do.
06-11-2009 10:59 PM
is management IP getting routed through ASA inside interface ? if yes then kindly get me the packet captures
access-list abc permit ip host
access-list abc permit ip host 198.133.219.25 host
capture cpi access-l abc interface
Intf.Name-->INterface on ASA which is part of same VLAN as IPS Mngmt IP
Also send me the latest show statistics host
06-23-2009 01:33 PM
To add to the wonderful comment by Ashish, I had the same problem and fixed it by changing the "//" after the IP address to "/".
02-12-2014 10:10 AM
What was is the CORRECT current URL which actually works in the real world; NOT lifted off some wrong documentation? I mean working URL - copy and paste from a working setup please?
Thanks
02-13-2014 11:21 PM
NOTE: Do not change the double slash (//) at the end of the IP address shown in this configuration.
sensor#config t
sensor(config)#service host
sensor(config-hos)#auto-upgrade
sensor(config-hos-aut)#cisco-server enabled
sensor(config-hos-aut-ena)#cisco-url https://72.163.4.161//cgi-bin/front.x/ida/locator/locator.pl
sensor(config-hos-aut-ena)#exit
sensor(config-hos-aut)#exit
sensor(config-hos)#exit
Apply Changes?[yes]:yes
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: