DTMF out-of-band on MGCP

Unanswered Question
Jun 10th, 2009
User Badges:

I would like to configure dtmf out of band for an issue I may be having on an MGCP gateway. The gateway, however, does not have dial-peers. MGCP gateways that are configured via cluster used to have dial-peers numbered in the 9XX range, I believe, but I've found that in more recent revisions that this is not the case. Does anyone know how this has changed and what recourse I have for this issue?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
shikamarunara Wed, 06/10/2009 - 09:55
User Badges:

There's an MGCP command;


mgcp dtmf-relay voip codec all mode out-of-band


That appears to be an equivalent. Is this what it is for?

parshah Wed, 06/10/2009 - 09:59
User Badges:
  • Cisco Employee,

Hi,


that command will do that trick.


thanks

harris.h Wed, 06/10/2009 - 10:24
User Badges:

Hi There

This may or may not be applicable,

taken from another forum post:


CSCso87127 in-band DTMF leakage of 40-50msec observed when using DTMF relay


May be worth checking out.

Nicholas Matthews Wed, 06/10/2009 - 17:26
User Badges:
  • Red, 2250 points or more

In all circumstances, the gateway will send a NTFY with D/.


This command allows for it to advertise the capability to CUCM and for CUCM to know to forward it on.


If you use 'ccm-manager config' this is an automatic configuration.



You can use 'debug mgcp packet' and you should see NTFY messages with the line D/1, D/2, etc in it.



-nick

Actions

This Discussion