Static Route Between Linksys RV082 and Cisco 2821 Router

Unanswered Question
Jun 10th, 2009

My configuration is a Linksys RV082 Dual-Wan Router that gets the two incoming internet connections and then on the switch port of the RV082 I have a Cisco 2821 connected. I need to know how to configure the RV082 to route all incoming/outgoing to the lan(2821) and internet.

The ip's are as follows:

Linksys LAN Interface-

Cisco LAN Interface-

Cisco WAN Interface-

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
mmacdonald70 Thu, 06/11/2009 - 03:16

If you don't want to use RIP, you could create:

Linksys -> 192.168.0.x (Cisco interface)

Cisco ->

You might also need to tell the Linksys to also nat any other networks that you are using (


This Discussion