leds in VIC2-4FXO are amber

Unanswered Question
Jun 10th, 2009
User Badges:

Hello, I have a 2811 router, and i need to install a VIC2-4FXO but leds are amber, with show ver command the 4 FXO ports appear but in sh run configuration the ports don't exist

Can you help me?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
paolo bevilacqua Wed, 06/10/2009 - 13:24
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Very likely you don't have the necessary DSP module (minimum of PVDM2-8).

You cannot use the FXO ports without these.

You check what you have with "show diag".

Nicholas Matthews Wed, 06/10/2009 - 18:10
User Badges:
  • Red, 2250 points or more

One of two problems:

If you do a 'show diag | i FRU' you should see PVDM2-X of some sort.

If there is, then you are either on ip base, enterprise base, or the security base feature set, and do not have the voice feature set in your IOS and need to upgrade your IOS feature set.


Mie1am900 Thu, 06/11/2009 - 06:48
User Badges:

Hello Thank you for attending to my question

I do show diag | i FRU look

yourname#show diag | i FRU

Product (FRU) Number : CISCO2811

Product (FRU) Number : VIC2-4FXO

Product (FRU) Number : NME-CUE

I do not have what they say to me.


This Discussion