06-10-2009 08:25 PM - edited 03-04-2019 05:04 AM
Hi, I want two global policies-
1. All ICMP reply should come from L0
2. All telnet Reply should come from L0
ICMP reply is working fine, but I am not getting telnet reply from L0. Please help.
access-list 101 permit icmp any any
access-list 101 permit tcp any any eq telnet
!
route-map RR permit 10
match ip address 101
set interface Loopback0
ip local policy route-map RR
06-10-2009 11:01 PM
Hi Rupesh,
is there any particular reason you want to achieve the same using a route-map.Else you can use
ip telnet source-interface loopback0
Regards,
Srinath M
+91 99809 30364
06-10-2009 11:17 PM
"ip telnet source-interface loopback0" will work if self router (R1) is generating telnet traffic for others. Here many hosts wants to telnet on R1 & R1 should always reply with its L0 address.
06-10-2009 11:42 PM
oh ok ok.. now got it.. so u want when u telnet from a host.. reply to go from the loopack 0..
06-11-2009 01:02 AM
Yes. any idea..as ICMP is working as per policy, only Telnet is not touching the ACL or Route-map
06-11-2009 04:08 AM
Rupesh
I am still not clear about what you are attempting to do. But I believe that the reason that ICMP does work and Telnet does not work is that your access list is identifying Telnet as the destination port. I believe that it would work if you identify Telnet as the source port. So rewrite the access list to look something like this:
access-list 101 permit tcp any eq telnet any
HTH
Rick
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: