PAP2T-EU

Unanswered Question
Jun 11th, 2009
User Badges:

Hello All!


I use CM 6.1.

I try connect PAP2T-EU to CM...

I have not expirience work with Linksys so I can not configure Linksys corret...


Can anybodu provide step by step configuration?


Thank you very much!!!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Patrick Born Thu, 06/11/2009 - 15:37
User Badges:
  • Cisco Employee,

Hi chernyakov,


Refer to the ATA Admin Guide for registration documentation. https://www.myciscocommunity.com/docs/DOC-2149

Here's a direct link: http://www.cisco.com/en/US/docs/voice_ip_comm/csbpvga/ata/administration/guide/ATA_AG_v3_NC-WEB.pdf


You should perform the following tasks, in order, so that you start from a known point:

1. Factory reset the device [page 226 in the "How do I access the ATA device if I forget my password?" section]

2. Upgrade to the latest firmware

3. Configure the device to register to your CM [starting on page 39 and then on to page 42]


Regards,



Patrick

----------

Mikhail Chernyakov Mon, 06/15/2009 - 01:04
User Badges:

Hello Patrick!

Thank you very much for useful links...

But I have some trouble...


Sopftware version of my device is 3.1.15(LS)

Is this latest version?

Where can I download new version?

Patrick Born Mon, 06/15/2009 - 10:03
User Badges:
  • Cisco Employee,

Hi chernyakov,


The current version of firmware is available from http://cisco.com/smallbusinessand then search on pap2t.

You need to log in as a guest, registered user, or partner in order to download firmware.


Regards,



Patrick

-----------

Ordenador Mon, 06/22/2009 - 05:10
User Badges:

Hello, Patrick!

Thank you very much for useful links, but we have some troubles else...

When we dial some number, dialing process last 10 seconds, but we need it last max 3 seconds... How we can configure this parameter?

Patrick Born Mon, 06/22/2009 - 15:33
User Badges:
  • Cisco Employee,

Hi Ordenador,


You can modify the Interdigit Long Timer from 10 to a shorter time in seconds:

PAP2T web-ui > Regional > Control Timer Values > Interdigit Long Timer: 3

More information in the Admin Guide:

https://www.myciscocommunity.com/docs/DOC-2149


Regards,



Patrick

-----------

Actions

This Discussion