Outpulse DTMF digits

Unanswered Question
Jun 11th, 2009
User Badges:

I'm trying to configure a speed dial to dial a number and then outpulse dtmf digits once the call is connected.


Does anyone know if there is a way to either insert pauses into a speed dial or allow a user to press a second speed dial after the call is connected?


Any help would be greatly appreciated.


Thanks,

Glenn

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Jaime Valencia Thu, 06/11/2009 - 06:49
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    2011

No option for either of that


CUCM has no means to insert pauses and speed dials cannot be used once a call is connected.


Only unity or H323 GWs using the comma (,) can insert a 1 second pause.


HTH


java


if this helps, please rate

paolo bevilacqua Sun, 04/28/2013 - 11:58
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Read Release Notes of 7.5.1a firmware, page 4. It may or may not apply to your case.

Will not apply, because these apply only to SPA phones, that are not support by CM or CME.

paolo bevilacqua Sun, 04/28/2013 - 11:39
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

I'm trying to configure a speed dial to dial a number and then outpulse dtmf digits once the call is connected.


Does anyone know if there is a way to either insert pauses into a speed dial or allow a user to press a second speed dial after the call is connected?

You can use my script "speed-dial with pauses" for this purpose. It can be acquired on the website mentioned in my profile.

Actions

This Discussion