Dead Air at the starting of the call..

Unanswered Question
Jun 11th, 2009

We have a weird situation when we receive a call via PSTN caller does not hear initially..Then we hear a busy tone and once we drop the call. We get ringback again and we connect and could continue the conversation. We have folloing setup..

CM (4.1.3)---H323--Cisco 2851--PSTN (ISDN PRI). We are running 12.4.12 on the 2851 router.. Any clue would be helpfull..

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
sheepate Thu, 06/11/2009 - 20:05

Check the voip dial peers on 2851 that sends calls to CUCM servers. It seems like call is not connecting via first choice.

eellarbee Tue, 06/16/2009 - 12:37

Check to see if you have a dial-peer with direct-inward-dial statement (for onestage incoming dialing)

Under dialpeers, sometimes it helps to put the "NO VAD" statement. VAD sometimes causes pauses for incoming calls.

rhegde Tue, 06/16/2009 - 12:56

It turned out to be a QoS misconfiguration for the signalling traffic, which was causing the call setup issues.. It is fixed now.. Thanks any ways..


This Discussion