Cisco 1010AP Can't find 4402 WLAN controller

Unanswered Question
Jun 11th, 2009

Hi folks,

I'm running a 4402 WLAN controller running 5.2 code. I've got some 1010APs that don't associate with the WLC. I'm trying to keep the setup basic. The access points are plugged into the same VLAN as the native vlan for port1 on the controller. I've setup a DHCP server in the manner documented. The WLAN controller is configured as a master server. This is the message that I get in the web interface for WLC:

AP with MAC 00:0b:85:6e:4a:90 (AP 1010 #1) is unknown.

Any clues as to what I'm doing wrong?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Forelis01 Fri, 06/12/2009 - 07:48

Thanks all! I had suspected there was a compatibility issue, but never saw that line in the release notes.

Leo Laohoo Thu, 06/11/2009 - 14:50

Hi Daniel,

Rob's right. If you want to use the 1000 series AP, you'll have to downgrade to the 4.x.x firmware.

George Stefanick Fri, 06/12/2009 - 04:35

I have 5 or 6 Airespace controllers i can sell you. They work GREAT with the 1000's .. :)


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode