No ringback and no-way audio

Unanswered Question
Jun 11th, 2009
User Badges:

CM 6 with MGCP gateway with two PRIs. Calls get completed but no ringback and no audio.


network-clock-participate wic 0

network-clock-participate wic 1

network-clock-select 1 T1 0/0/0

network-clock-select 2 T1 0/1/0

isdn switch-type primary-ni

voice call send-alert

voice rtp send-recv

voice-card 0

dspfarm

dsp services dspfarm

interface Serial0/0/0:23

no ip address

encapsulation hdlc

isdn switch-type primary-ni

isdn incoming-voice voice

isdn bind-l3 ccm-manager

no cdp enable


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4.5 (2 ratings)
Loading.
kifleak19 Fri, 06/12/2009 - 01:59
User Badges:

Hi,


Add the following under dial-peer pots:

progress_ind setup enable 3

progress_ind alert enable 8

progress_ind progress enable 8

dezoconnor Fri, 06/12/2009 - 02:52
User Badges:
  • Silver, 250 points or more

No need to add the above config as you're using mgcp not h323. Anyway, is there a firewall involved in this setup at all? You could be dropping RTP packets (udp ports 16384-32xxx, sorry can't remember them off the top of my head). Either that or a routing issue. Can you Ping any of your ip phones from your voice gateway?

Actions

This Discussion