06-12-2009 06:32 AM - edited 03-21-2019 01:12 AM
I just bought an ATA 186 to connect my fax machine to the network. The manual says that the ATA is suppose to register like a phone to the CME, but when I plug that ATA to the network, CME doesn't see it and it's getting an IP address like a regular network device not a IP Phone. Has this happen to anyone or anyone have experience will the ATA 186?
06-12-2009 08:14 AM
Is this CME a UC500? If not, then you need to make sure that your configuration is correct:
Thanks,
Marcos
11-06-2009 06:42 AM
might be a little bit late :-) but this did the trick for me:
using the MAC adress as SID0:
For SID01:
1. Drop the first 2 nibbles of the MAC address and shift the MAC address to the left.
2. Add 01 to the right end of the MAC address. For example, 00070EA26032 is port 1 and 070EA2603201 is port 2.
3. Use this new MAC address and register this as a device to the Cisco CallManager.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: