Firewall Configuration Issue

Unanswered Question
Jun 12th, 2009


i am having some issue while configuring PIX firewall in my network.

Please find the network digram for your refernce abt the setup.

As per diagram i am able to reach the firewall using inside interface ip address from remote end Lan.

but there is no traffic passing between outside to inside even if i kept permit ip any any ACL rule.

Can some one send me the basic configuration as per the network diagram.

It will be great help for me.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
chaitu.kranthi Sat, 06/13/2009 - 01:11


Thanks for your quick reply,

apology for missing the configuration.

Please find the config & network diagram as attachment.

correct me if i am wrong at any where.

My requirement is outside lan has to access remote server through inside interface with out any nat.

Farrukh Haroon Sat, 06/13/2009 - 04:58

Can you mention any SPECIFIC flow you are trying to test?

e.g. telnet x.x.x.x port

Also your default route statement seems to be wrong:

route inside 1

The interface you mention is 'inside' but the next-hop is actually the FW's outside interface IP??

It should be the following I guess:

route inside 10.62.248.XX

Also is your inside interface mask correct? Is it supposed to be /27?



hussain.ratlami Mon, 06/15/2009 - 05:02


check your route command, it should be

route inside

also if you have done any Natting, you have to create a NAT exempt rule for the network range you dont want to b Natted.

Let me know for any help you require


This Discussion