06-12-2009 03:56 PM - edited 03-11-2019 08:42 AM
Hi,
i am having some issue while configuring PIX firewall in my network.
Please find the network digram for your refernce abt the setup.
As per diagram i am able to reach the firewall using inside interface ip address from remote end Lan.
but there is no traffic passing between outside to inside even if i kept permit ip any any ACL rule.
Can some one send me the basic configuration as per the network diagram.
It will be great help for me.
06-12-2009 10:56 PM
You forgot to attach (I think).
Also post your sanitized configuration.
http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_tech_note09186a008009402f.shtml
Regards
Farrukh
06-13-2009 01:11 AM
06-13-2009 04:58 AM
Can you mention any SPECIFIC flow you are trying to test?
e.g. telnet x.x.x.x port
Also your default route statement seems to be wrong:
route inside 0.0.0.0 0.0.0.0 10.62.249.254 1
The interface you mention is 'inside' but the next-hop is actually the FW's outside interface IP??
It should be the following I guess:
route inside 0.0.0.0 0.0.0.0 10.62.248.XX
Also is your inside interface mask correct? Is it supposed to be /27?
Regards
Farrukh
06-15-2009 05:02 AM
Hi,
check your route command, it should be
route inside 10.62.242.0 255.255.255.0 10.62.248.62
also if you have done any Natting, you have to create a NAT exempt rule for the network range you dont want to b Natted.
Let me know for any help you require
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide