French BRI Configuration

Unanswered Question
Jun 13th, 2009

HI all,

What's the french configuration for BRI?

-          Basic 5ESS

-          Basic DMS100

-          Basic NI

-          NTT

-          Basic NET3

-          Basic 1TR6

-          VN3

-          Basic QSIG

and

Bearer capability : speech or 3100 HZ or none

and

ISDN Static TEI : none,0,1,2,3,4,5,6,7,8,9

Regards

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Marcos Hernandez Sun, 06/14/2009 - 06:36

This is a sample CLI configuration for a BRI connection in France:

isdn switch-type basic-net3

!
interface BRI0/1/0
no ip address
no logging event link-status
isdn switch-type basic-net3
isdn tei-negotiation first-call
isdn point-to-point-setup
isdn incoming-voice voice
!

Bearer CAp. should be "Speech".

Some configurations require a static TEI, typically "0". Finally, sometimes inbound calls fail due to the fact that IOS disables the dial-peers when the Layer 1 goes down. To avoid this, you will need to enter this global command: "no dial-peer outbound status-check pots".

Thanks,


Marcos

final-reseaux Sun, 06/14/2009 - 08:04

Where i paste this line:  "no dial-peer outbound status-check pots".

Regards

final-reseaux Sun, 06/14/2009 - 09:54

this is BRI Port conf with CCA 2.0, is it true or not

!

interface BRI0/1/0

no ip address

isdn switch-type basic-net3

isdn point-to-point-setup

isdn incoming-voice voice

isdn sending-complete

trunk-group ALL_BRI 64

!

interface BRI0/1/1

no ip address

isdn switch-type basic-net3

isdn point-to-point-setup

isdn incoming-voice voice

isdn sending-complete

trunk-group ALL_BRI 64

!



Regards

Actions

This Discussion