Policing: Calculate burst rate

Unanswered Question
Jun 13th, 2009
User Badges:

Looking at configuring policing on a layer3 port on a 6500 switch. How do I calculate the burst rate to limit the port to allow a max of 600MB ingress/egress on a 1GB port


### 6500 ###



!- QOS


mls qos


!- ACL


access-list 101 permit tcp 172.16.35.152 0.0.0.0 172.18.0.0 0.0.0.255

access-list 101 permit tcp 172.16.38.100 0.0.0.0 172.18.0.0 0.0.0.255


access-list 102 permit tcp 172.18.35.125 0.0.0.0 172.16.0.0 0.0.0.255

access-list 102 permit tcp 172.18.38.100 0.0.0.0 172.16.0.0 0.0.0.255



!- class map


class-map Police

match ip address 101

match ip address 102



!- Policy map


policy-map Traffic

class Police_OUT

police 600000000 conform-act transmit exceed-act drop



Please advise.



!- L3 Port


int G5/1

service-policy in traffic

service-policy out trafic

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
leekleybm Sat, 06/13/2009 - 21:32
User Badges:

I don't think the 6500 will support full MQC. Commands like police, bandwidth, etc. are not going to be taken.


Can anyone else confirm?

leekleybm Sun, 06/14/2009 - 06:16
User Badges:

Sorry, just realized I gave you an answer that provided zero help. You will want to check out the 6500 documentation for PFC QoS. Specifically the sections for aggregate and micro-flow policers. Basically, you build the mls qos aggregate-policer, then apply that to the class-map.


http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/ios/12.2SXF/native/configuration/guide/qos.html

Actions

This Discussion