Leased Line link error and bandwidth check

Unanswered Question
Jun 14th, 2009
User Badges:

Hi,

I'm implementing a WAN on leased line.Service provider of leased line always says thier lines are ok, but actually i faced problem with link.

Can anyone tell how can i check link error and bandwith currentely getting from service provider through ROUTER.


Regards,

Siddhartha

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Giuseppe Larosa Sun, 06/14/2009 - 23:44
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    Founding Member

Hello Siddharta,


the first basic check is to use


sh interface serial x/y


command and to see if there are errors of any type.

Repeat the commands every 5 minutes to see if error counters are incrementing.


Here it is a link for serial lines troubleshooting


http://www.cisco.com/en/US/docs/internetworking/troubleshooting/guide/tr1915.html


possibly compare the outputs of routers at both ends of the link.


Hope to help

Giuseppe


Actions

This Discussion