06-15-2009 03:49 AM - edited 03-06-2019 06:15 AM
After a power down we booted up our core switched 4507 and 4510 and both went into rmon mode. Both supervisors had amber leds I had to attach a console cable to each supervsior and boot from command line and it reloaded with correct config. Any help with this would be appreciated
06-15-2009 04:14 AM
How is the setting of the config-register for the switches? See the last line of 'show version' after the switches have been fully booted.
The config-register should be something like 0x2102 or 0x2 or 0xF
HTH
06-15-2009 04:22 AM
The config register is 0x2102
06-15-2009 11:44 AM
Did you have a "boot system xxx" statement in your config before you reloaded? I just found this note in the documentation:
If you set bootfield to a value between 0-0-1-0 (binary) and 1-1-1-1 (binary), you must specify a value in the boot system command, else the switch cannot boot up and will remain in ROMMON.
So with your 0x2102 you must have a 'boot system' statement in the config.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: