2811 not detecting additional FEs

Unanswered Question
Jun 15th, 2009

Dear All,

I am trying to install 2 additional HWICs ( 2*FE) in a 2811 router but it is not detecting these interfaces. I am getting following message in logs,

"GT96K_FEWAN-1-UNKNOWN_WIC: NM slot 0, wic card has an unknown id 53A"

What could be the possible solution ? IOS version on Router is 12.4(23)

Thanks

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
rmujeeb81 Mon, 06/15/2009 - 23:53

Thanks for your response. I was trying to install 2 * HWIC-1FE means there were 2 different single FEs. So it needs IOS compatibility ?

Thanks

Leo Laohoo Tue, 06/16/2009 - 13:59

Whoopsie! I thought you had a type-o. In this case, yes, the minimum level is Cisco IOS 12.4(15)T.

But wait ... why is the error "NM slot 0"? Where are you inserting the HWIC-1FE?

rmujeeb81 Tue, 06/16/2009 - 21:53

The current IOS version is 12.4(23). I tried to install on all available slots.

Thanks.

Actions

This Discussion