06-15-2009 10:55 PM - edited 03-11-2019 08:43 AM
Hi folks,
is there a way of issuing a command to tell you what switch you are on when you are logged into the FWSM ie if switch name is SW1 and the FWSM is FWSM1. How would I know that I'm on SW1?
06-16-2009 12:39 AM
I use the "show failover"... it will show you if you are on the "Primary" fwsm.
Regards.
06-16-2009 12:44 AM
i dont think you can!. might be wrong.
06-16-2009 12:49 AM
Without wishing to state the obvious we used to just name the FWSM so you could match it up with the switch ie.
switch = DC-BBP-F00-DS1
FWSM = DC-BBP-F00-DS1-FWSM1
etc..
Jon
06-16-2009 12:52 AM
extactly what we do.
in jon's example, we use
SW-DC-BBP-F00-DS1
FW-DC-BBP-F00-DS1
FW for the FWSM
SW for the SW hosting the FWSM..
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: