cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
616
Views
0
Helpful
5
Replies

Troubleshooting with ip communicator and VT advantage

aherraez77
Level 1
Level 1

Hello:

I have a Ip communicator version 2.0.1 and a CME 4.3. In theory I should see the camera icon in the screen of the IP communicator but I don't see it.

I have another problem wiht the VT advantage. It don't see the IP communicator. I don't know if the cause is the first problem o it is another problem.

I have configured in Telephone-service: service phone videoCapability 1

video

maximum bit-rate 384

and in the phone I have the video command.

What can I see or do for the two problems?

Thanks everybody

antonio

5 Replies 5

david-lima
Level 4
Level 4

Hi Antonio, please verify under Telephony-services:

telephony-service

service phone videoCapability 0

video

maximum bit-rate value

And reset the phones where the video command is applied.

All the best

David

Hi,

service phone videoCapability 1

Best regards

David

Hello:

I have that commands. But it is 0 or 1?. I have read that 1 is for enable it and 0 for disable.

the phones have been reseted too. Now I have the Ip communicator 7 and the result is the same: the camera icon doesn't appears

regards

Hi again, try disabling service phone videoCapability and enable it again, then apply the command create cnf-files and reset the phones.

All the best

David.

Hello:

It does't work, but I have used the command type CIPC and all goes fine. Now I have the camera icon and video.

Thanks for all

antonio

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: