06-16-2009 01:56 AM - edited 03-17-2019 09:45 PM
Hello:
I have a Ip communicator version 2.0.1 and a CME 4.3. In theory I should see the camera icon in the screen of the IP communicator but I don't see it.
I have another problem wiht the VT advantage. It don't see the IP communicator. I don't know if the cause is the first problem o it is another problem.
I have configured in Telephone-service: service phone videoCapability 1
video
maximum bit-rate 384
and in the phone I have the video command.
What can I see or do for the two problems?
Thanks everybody
antonio
06-16-2009 05:45 AM
Hi Antonio, please verify under Telephony-services:
telephony-service
service phone videoCapability 0
video
maximum bit-rate value
And reset the phones where the video command is applied.
All the best
David
06-16-2009 05:52 AM
Hi,
service phone videoCapability 1
Best regards
David
06-16-2009 05:53 AM
Hello:
I have that commands. But it is 0 or 1?. I have read that 1 is for enable it and 0 for disable.
the phones have been reseted too. Now I have the Ip communicator 7 and the result is the same: the camera icon doesn't appears
regards
06-16-2009 06:02 AM
Hi again, try disabling service phone videoCapability and enable it again, then apply the command create cnf-files and reset the phones.
All the best
David.
06-17-2009 04:35 AM
Hello:
It does't work, but I have used the command type CIPC and all goes fine. Now I have the camera icon and video.
Thanks for all
antonio
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: