06-16-2009 06:39 AM - edited 07-03-2021 05:43 PM
I was trying to update the firmware on my 1200, and now it says "The system is unable to boot automatically because there
are no bootable files to boot.
it sits at a "ap:" prompt and will not allow me to enter "enable" mode. HELP!
06-16-2009 07:49 AM
Your easiest option would probably be to reload the image with the mode button procedure
http://cisco.com/en/US/docs/wireless/access_point/12.4_3g_JA/configuration/guide/s43trb.html#wp1038660
06-16-2009 08:03 AM
Thanks Dan,
I just found the same doc minutes ago.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Log in to Community
