We are trying to log CLI commands to Cisco ACS version 3.1 from Nortel Passport 8600's. The version of code running on passports does not support tacacs+.
The Passports authenticate okay but do not log any command information. I "think" the problem may be that the Radius Nortel VSA for cli-commands-attribute, 195, is not being collected by ACS.
Does anyone know how I would go about getting this VSA added in to the existing Radius(Nortel) list?
You need to add Nortel attribute 193-195 to enable command accounting.
Unfortunately you cannot upload it on 3.x code, so you need to upgrade acs to 4.x code.
Do rate helpful posts