VSS device marked as "Unknown" in DFM 3.1.0

Unanswered Question
Jun 17th, 2009


I have LMS3.1

When I import device in DFM =(3.1.0) the Cat-6506(sw 12.2.33) configured as VSS device are not known.

Allthough the other Cat-6506(Sw 12.2.33) not configured as VSS are known.

Have you an idea?


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Marvin Rhoads Wed, 06/17/2009 - 07:42

According to the supported device table for LMS 3.1 (http://www.cisco.com/en/US/docs/net_mgmt/ciscoworks_lan_management_solution/3.1/device_support/table/lms31sdt.html), only the 6513 flavor of the VSS is supported. (objectID That seems counter-intuitive, since it's the Supervisor that makes it a VSS, but may be the case. Can you tell us the objectID of your target VSS switch?

Perhaps jclarke can weigh in with a more definitive answer.... Joe?

mmisonne Wed, 06/17/2009 - 08:13

Yes indeed, snmpwalk on the VSS 6506 device tell me:


mmisonne Thu, 06/18/2009 - 02:39


If oid of 6506-VSS is the same as OID of 6513-VSS , why does'nt it work ?

Do I need to upgrade DFM 3.1.0 to 3.1.3 ?



This Discussion