cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
530
Views
5
Helpful
5
Replies

PtoP T1 cannot traceroute between routers

dkordyban
Level 1
Level 1

While logged in console to router I cannot traceroute to the other side of the t1 link. I can ping it. I have no acls setup.

5 Replies 5

Giuseppe Larosa
Hall of Fame
Hall of Fame

Hello David,

check if the other side is configured with

int serx/y

no ip unreachables

this can block the icmp unreachable that would be send back in response to UDP traceroute probe.

Hope to help

Giuseppe

Thank you for your response. I checked and that command was not in there. What is weird is that I can tracert from 1 site but not the other. I have tried replacing router, cables switches CSU/DSU. I do notice alot of input errors and crc erros on both CSU/DSU for that link. Could it be telco wiring?

Thanks again

Hello David,

if the link is errored you have to worry about it.

use the following links as a reference

http://www.cisco.com/en/US/docs/internetworking/troubleshooting/guide/tr1915.html

http://www.cisco.com/en/US/tech/tk713/tk628/technologies_tech_note09186a00800a758d.shtml

depending on the type of errors you may need to ask the provider to perform loop tests to verify the link.

You may see the link as made of three segments:

R1- to CSU/DSU --- wan --- CSU/DSU -- R2

all three sections have to be investigated.

Hope to help

Giuseppe

It was indeed telco issue. After testing a second time from the opposite side they found a Card set for AMI framing in the Span.. everything else was set for B8zs.

Hello David,

nice to know you solved this issue and you have been kind to report the solution here.

Best Regards

Giuseppe

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco