Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
317
Views
5
Helpful
3
Replies

WCCP Direction IN and OUT

Rupesh Kashyap
Level 1
Level 1

‎06-18-2009 12:25 AM - edited ‎03-04-2019 05:10 AM

Hi, I am confused with WCCP direction. I have L3 switch. Content device is attached on E0/0 & desktops are connected on other interfaces,like e0/2, e0/3. Please help me about commmand "IP WCCP Web Redirect OUT/IN". IN direction will on E0/0 where Content device is connected or any other logic ?

Labels:
0 Helpful
3 Replies 3

johnspaulding
Level 1
Level 1

‎06-18-2009 07:11 AM

rupesh

Since the redirection is local on the switch itself you should need the following commands

ip wccp web-cache (enable web-caching)

under the e0/0 interface you will need the following command

ip wccp web-cache redirect in

If the content device was external (across the MPLS, ect) than you would redirect outbound. Hope this helps

Rupesh Kashyap
Level 1
Level 1
In response to johnspaulding

‎06-18-2009 07:35 AM

Any command for sw ports where desktops are connected ?

0 Helpful

johnspaulding
Level 1
Level 1
In response to Rupesh Kashyap

‎06-18-2009 11:24 AM

no, that should be all you need. And you are just wanting to use this for web caching correct? Because we use it for port-redirection for Riverbed traffic to optimize..

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card