Dynamic L2L - Static tunnel not working

Unanswered Question


I must configure a 2821 with one dynamic ipsec peer, one static ipsec peer and vpn clients but I guess I am missing something, I wonder if someone can help me.

I have figured how to configure the devices by following some Cisco VPN documentations but I just can't get the static peer to work, it seem to be asking for Xauth and I can't find a way to bypass it. The dynamic peer and VPN Clients are working perfectly.

Router config and isakmp debugs are attached.



I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
auraza Fri, 06/19/2009 - 06:37

What about the debugs on the other side? Looks like it could be a pre-shared-key mismatch, because of the way your profiles / keyrings may be set up.


This Discussion