06-18-2009 02:09 PM - edited 03-04-2019 05:10 AM
Hi
Can Everybody tell me how can I clear the counters of the policy-map statistics in an 7600 and the 1841 router?
thanks
06-18-2009 02:23 PM
clear counters FastEthernet0/1 (or any other interface)
06-18-2009 02:40 PM
hi Greg.
but that command doesnt clear the drops stadistics? tks
06-19-2009 09:23 AM
It should, what IOS are you running? Send me the output of sh policy-map int before and after clearing the counters.
06-26-2009 01:32 PM
You could bounced the qos policy config...take it out and put it back in.
08-05-2010 09:39 AM
Hi,
Ran accross this too,
Routeur wouldn't clear the policy-map counters (sh policy-map int xx) when clearing the specific interface...
Try clearing counters for all interfaces, worked for me..
ie:
clear counters
!## Make sure you hit enter to confirm at this prompt : Clear "show interface" counters on all interfaces [confirm]
Good Luck
12-16-2011 07:48 AM
Hi,
On my Cisco 2821 I used the following to clear the Service Policy counters on the Multilink interface.
clear counters mu1
or
clear counters multilink 1
Hopes this helps.
Chad
01-13-2017 12:38 PM
clear qos counters int XXXXBLA.BLA.BLA (as an example)
01-13-2017 12:38 PM
My prior response is on a 9K
01-05-2018 10:29 AM
05-15-2019 11:02 AM
The only way I could reset the policy-map counters on an interface was remove it from the interface and put it back on.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: