Buy or Renew
Buy or Renew
Cisco Virtual Engineer generative AI bot now active in Wireless Discussion Forum. Learn more.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
310
Views
0
Helpful
2
Replies

I can not push the configuration to the controllers

hamsofiane
Level 1
Level 1

‎06-19-2009 02:19 AM - edited ‎07-03-2021 05:44 PM

Involved hardware / software:

2x Cisco 6509E in VSS-1440 configuration

6509E running software version 12.2(33)SXI

2x WS-SVC-WISM-1-K9 WiSM module (1 per 6509)

WiSM running software version 4.2.205.0

1x WCS version 4.2.128.0

This is according to Cisco the WCS version to use with the WiSM software version 4.2.205.0 - it was released for this version

Configuration that makes problems:

• First: I configure an ACL on the WCS - this is correctly pushed to the Controller configuration

• Second: I set the configured ACL as “Preauthentication ACL” for the web authentication

• This setting is NOT pushed to the controllers - I have to configure it via the CLI every time I apply the WLAN settings.

Labels:
0 Helpful
2 Replies 2

mchin345
Level 6
Level 6

‎06-25-2009 06:32 AM

Delete the controllers having the issue From WCS and re-added them in. then try to push the configuration.

0 Helpful

Leo Laohoo
Hall of Fame
Hall of Fame

‎06-25-2009 03:33 PM

WiSM running software version 4.2.205.0 and WCS version 4.2.128.0?

Shouldn't the WCS be of the higher version?

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card