06-19-2009 06:59 AM - edited 03-06-2019 06:21 AM
We dropped a 6500 with no power supplies. We had to prop the bottom of the chassis with wood to get the power supplies in. What commands are available to take a look at the hardware and see what specific problems exist with the linecards, supervisor etc.?
06-19-2009 07:13 AM
Maybe try a sh module.
06-19-2009 08:42 AM
I would configure the following, "diagnostic bootup level complete" and reload the switch. This will do a complete diag and once the switch is up perform a "sh diagnostic result".
06-21-2009 10:05 PM
sh test would do.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: