06-19-2009 10:04 AM
Hi,
I am stuck in enabling communication between GRT & VRF in 7609. I have tried following thing but no success & I am stuck in a project migration b/c of this. Any feedback would be appreciated.
RouterA:
int vlan10
ip add 1.1.1.1 255.255.255.0
int vlan 100
ip vrf forwarding CUST
ip add 2.2.2.2 255.255.255.0
ip route 2.2.2.2 255.255.255.255 vlan100
ip route vrf CUST 1.1.1.1 255.255.255.255 vlan10
arp 2.2.2.2 aa11.bb11.cc11 arpa
arp vrf SHARED 1.1.1.1 aa22.bb22.cc22 arpa
RouterA:
ping 2.2.2.2 source 1.1.1.1 (timeouts)
ping 1.1.1.1 source 2.2.2.2 (timeouts)
Regards,
Akhtar
06-19-2009 10:36 AM
you need to point your static route to the loopback address of the GRT and also to your vrf loopback address:
ip route 2.2.2.0 255.255.255.0 Loopback0 1.1.1.1
in the above static route loopback0 is the GRT loopback and 1.1.1.1 is the VRF loopback address.
This is how I got mine working
HTH
Reza
06-19-2009 10:55 AM
you need to point your static route to the loopback address of the GRT and also to your vrf loopback address:
ip route 2.2.2.0 255.255.255.0 Loopback0 1.1.1.1
in the above static route loopback0 is the GRT loopback and 1.1.1.1 is the VRF loopback address.
This is how I got mine working
HTH
Reza
06-19-2009 11:21 AM
Hi reza,
Thanks for your feedback. But its not working still. Can you paste your configs & output(with arp & vrf arp)
Regards,
Akhtar
06-19-2009 01:33 PM
Akhtar,
I did not configure arp or vrf arp.
I posted a similar question on the 15th of this month. Go ahead and check it out to see if it helps you in resolving this.
I also atteched my config in that post
HTH
Reza
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide