06-19-2009 11:38 AM - edited 03-15-2019 06:37 PM
If a call comes in on an FXO and I want to ring both an analog phone (on an FXS port) and an IP phone at the same time when this occurs - how to configure this? hunt-group?
06-19-2009 11:50 AM
You need to configure the FXS port in SCCP mode - the manual explains how to do that.
06-19-2009 12:39 PM
I think I found the answer in hunt-group parallel..
..aka "Call Blast"
06-19-2009 12:42 PM
Not sure if hunt -group paralles support s pots DP.
06-19-2009 12:47 PM
..and worse if you're using prior to 4.3 CM software only SIP phones are supported. :-( But perhaps if I upgrade to 4.3 and use your SCCP command on the FXS port I'd be in business??
06-19-2009 12:49 PM
SCCP controlled ports is from 4.0 or so (I may be wrong). Then you don't necessarily need hunt-group, a shared line can be is enough.
06-19-2009 01:21 PM
Hi mmedwid,
A shared line will accomplish this.
Regards,
Justin
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide